Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Specification for Copper-Clad Steel Electrical Conductor for Tracer Wire Applications
Name übersetzen
NORM herausgegeben am 1.10.2019
Bezeichnung normen: ASTM B1010/B1010M-19
Ausgabedatum normen: 1.10.2019
SKU: NS-972575
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
annealed copper-clad steel wire, center conductor locating wire, center conductor tracer wire, clad steel electrical conductor, copper electrical conductor´copper-clad steel, copper-clad steel electrical conductor, electrical conductor, hard drawn copper-clad steel wire, locate wire, locating wire, steel wire´copper-clad, trace wire, tracer wire,
Significance and Use |
14.1 Twist Test—This test is designed to detect surface related issues such as flaking or cracking in the shell as well as core integrity of the wire related to elongation. Failures under the specified requirements could lead to insulation failures allowing moisture and other factors to affect wire performance. 14.2 Reverse Torsion—This test is designed to detect copper and core steel bonding issues which could lead to corrosion and eventual signal failure through the wire. |
1. Scope |
1.1 This specification covers bare round 21 % conductivity copper-clad steel wire for the center conductor in tracer wire, also known as locating wire. 1.2 Two grades of copper-clad steel wire are covered as follows: 1.2.1 21EHS: Nominal 21 % Conductivity Extra High Strength 1.2.2 21EHS-A: Nominal 21 % Conductivity Extra High Strength-Annealed 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-09-08 (Zahl der Positionen: 2 346 217)
© Copyright 2024 NORMSERVIS s.r.o.