Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Measuring and Recording the Deviations from Flatness in Copper and Copper Alloy Strip
Automatische name übersetzung:
Standard Test Methode zur Messung und Aufzeichnung der Abweichungen von Planheit in Kupfer und Kupferlegierungen
NORM herausgegeben am 1.10.2010
Bezeichnung normen: ASTM B754-10
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.10.2010
SKU: NS-7972
Zahl der Seiten: 5
Gewicht ca.: 15 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
edge wave, flatness measurement, strip distortion, strip flatness, wavy edge, Wavefront deviation/distortion, Wavy edges, Buckles, Copper alloy plate/sheet/strip/rolled bar--specifications, Deviation, Dish distortion, Distortion, Flatness--metallic materials/applications, Herringbone, Longitudinal corrugation, ICS Number Code 77.150.30 (Copper products)
Significance and Use | ||||
This test method is intended for measuring distortion in strip used for making close tolerance parts. Since distortion in this strip would influence the shape of the part being produced and cause difficulties in feeding through close-fitting dies and other manufacturing equipment, it is important that this material be flat. This test method provides a universal procedure for measuring the irregularities that cause the deviation from flatness. This test method allows the purchaser and manufacturer to inspect strip with a standard technique to a mutually agreed upon and acceptable percentage deviation from flatness. |
||||
1. Scope | ||||
1.1 This test method describes a procedure for the measurement of distortions in thin metal strip and the application of these measurements to an equation that will indicate the deviation from flatness. 1.2 The distortions to be measured in this test method are dish, wavy edges, buckle, longitudinal corrugation, and herringbone. 1.3 This test method is not intended to include the measurement of coil set or longitudinal curl, camber or edgewise curvature, or twist. 1.4 This test method is limited to metal strip 0.003 to 0.020 in. (0.08 to 0.50 mm) thick and not more than 6.0 in. (150.0 mm) wide. 1.5 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6 The following safety hazard caveat pertains only to the test method(s) described in this test method. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-11-22 (Zahl der Positionen: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.