Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Turner and Newall (T and N) Wet-Length Classification of Asbestos
Automatische name übersetzung:
Standard Test Method for Turner und Newall (T und N) Wet -Length Klassifizierung von Asbest
NORM herausgegeben am 1.6.2004
Bezeichnung normen: ASTM C1121-04
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.6.2004
SKU: NS-9588
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
asbestos, classification, length, length classification, T and N, Turner and Newall, wet length, wet length classification, ICS Number Code 91.100.40 (Products in fibre-reinforced cement)
1. Scope | ||||||||||||||||||
1.1 This test method covers the operation of the Turner and Newall (T and N) wet sieving classifier for asbestos, and a procedure for the determination of fiber length distribution and fines (defined in Terminology D 2946) content of milled asbestos fiber (-74 μm (200 mesh)) sieve described in Specification E 11. 1.2 For purposes of estimating length distribution, the test is limited to samples free from excessive quantities of non-fibrous particles or contaminants. Quantities exceeding 0.05 g retained in any given length fractions are considered excessive. 1.3 For comparisons between different fiber grades, only those specimens which have approximately the same degree of fiberization as determined by Test Methods D 2752 will give completely meaningful results. 1.4 This test method is not applicable to ultrafine grades of asbestos powders which contain little or no fibers retained on a 74-μm (200 mesh) sieve. This method is restricted to Quebec Standard grades 4A to 7D inclusive as determined by Test Method D 3639. Note 1—This is an alternative procedure to Test Method D 2589. 1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Letzte Aktualisierung: 2024-12-22 (Zahl der Positionen: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.