Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Determination of Loose and Tapped Bulk Density of Plutonium Oxide
Automatische name übersetzung:
Standard Test Methode zur Bestimmung der Lose und Rüttelschüttdichte Plutoniumoxid
NORM herausgegeben am 1.1.2013
Bezeichnung normen: ASTM C1770-13
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.1.2013
SKU: NS-12394
Zahl der Seiten: 3
Gewicht ca.: 9 g (0.02 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
apparent density, nuclear materials, packed density, powder metallurgy, ICS Number Code 27.120.30 (Fissile materials and nuclear fuel technology)
Significance and Use | ||||||||||||||
5.1 This test method is intended for determination of bulk loose or tapped density or both for plutonium oxide or similar metallic powders or compounds in the nuclear industry. It is intended for use when the quantity of available material for performing the measurements is limited because of reasons such as nuclear safety or laboratory scale limits on nuclear inventory. 5.2 Values of loose bulk density obtained using this test method should be used with caution since they can vary considerably depending on the initial state of dispersion of the test specimen, height-to-diameter ratio of the specimen in the graduated cylinder, the dryness of the powder, and other factors. 5.3 The data from the tapped bulk density test can be used to estimate the needed volume of small containers holding a fixed mass of powder that has been compacted. 5.4 This test method may be useful for the determination of the Carr Compressibility Index as described in Test Method D6393. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This test method specifies a method for the determination of loose and tapped bulk density of plutonium oxide powder. 1.2 This test method is applicable when limited quantities of powder are available for performance of the measurements. Alternative test methods, such as Test Methods B527 or D7481, may be used when sufficient quantities are available. 1.3 This test method contains notes that are explanatory and are not part of the mandatory requirements of the method. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historisch
1.6.2011
Historisch
1.1.2012
Historisch
1.12.2008
Historisch
1.6.2011
Historisch
1.6.2009
Historisch
1.6.2012
Bereitstellung von aktuellen Informationen über legislative Vorschriften in der Sammlung der Gesetze bis zum Jahr 1945.
Aktualisierung 2x pro Monat!
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-12-23 (Zahl der Positionen: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.