Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Twist in Single Spun Yarns by the Untwist-Retwist Method
Automatische name übersetzung:
Standard Test Method for Twist in Einzelgarnevom Untwist - Retwist Method
NORM herausgegeben am 10.11.1999
Bezeichnung normen: ASTM D1422-99
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 10.11.1999
SKU: NS-17235
Zahl der Seiten: 5
Gewicht ca.: 15 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
spun yarn, twist, ICS Number Code 59.080.20 (Yarns)
1. Scope | ||||||
1.1 This test method describes the determination of twist in single spun yarns when only an approximation of the true twist is required. For a more accurate method see Test Method D1423. 1.2 This test method is applicable to spun single yarns in continuous lengths, and also to spun yarns raveled from fabrics, provided specimens at least 200 mm (8 in.) long can be obtained. 1.3 This test method is not applicable to yarns that have been subjected to any chemical treatment or mechanical process that results in a condition that prevents easy removal of twist from the yarn, nor to bast fiber yarns in which the bundles of fibers split, nor to yarns that extend more than 5.0% when tension is increased from 2.5 to 7.5 mN/tex (0.25 to 0.75 gf/tex). 1.4 This test method has been found satisfactory for use in determining twist in all single ring spun yarns and 100% cotton open-end yarns. For all open-end spun yarns that are not 100% cotton this test method has not been found to be satisfactory for determining twist but may be used to measure deviation from an average value. 1.5 This specification shows the values in both inch-pound units and SI units. The "inch-pound" units is the technically correct name for the customary units used in the United States. The "SI" units is the technically corrected name for the system of metric units known as the International System of Units. The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values expressed in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining in any way. 1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.> |
||||||
2. Referenced Documents | ||||||
|
Bereitstellung von aktuellen Informationen über legislative Vorschriften in der Sammlung der Gesetze bis zum Jahr 1945.
Aktualisierung 2x pro Monat!
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-11-21 (Zahl der Positionen: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.