Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Specification for Reinforced Epoxy Resin Gas Pressure Pipe and Fittings
Automatische name übersetzung:
Standard-Spezifikation für verstärktem Epoxidharz Gasdruck Rohre und Fittings
NORM herausgegeben am 15.11.2011
Bezeichnung normen: ASTM D2517-06(2011)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 15.11.2011
SKU: NS-20634
Zahl der Seiten: 6
Gewicht ca.: 18 g (0.04 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
filament wound, compression molded, configuration of joining system, rupture srength, crush strength, chemical resistance, apparent tensile properties, adhesive, Shear testing--adhesives, Compression-molded plastic specimens, Configuration of joining system, Filament-wound plastic pipe, Gas pressure systems/applications--specifications, Reinforced thermosetting-resin pipe (RTRP)--specifications, ICS Number Code 23.040.20 (Plastic pipes), 23.040.45 (Plastic fittings)
1. Scope | ||||||||||||||||||||||||||||||||||||||
1.1 This specification covers requirements and methods of test for materials, dimensions and tolerances, hydrostatic-burst strength, chemical resistance, and longitudinal tensile properties, for reinforced epoxy resin pipe and fittings for use in gas mains and services for direct burial and insertion applications. The pipe and fittings covered by this specification are intended for use in the distribution of natural gas, petroleum fuels (propane–air and propane–butane vapor mixtures), manufactured and mixed gases where resistance to gas permeation, toughness, resistance to corrosion, aging, and deterioration from water, gas, and gas additives are required. Methods of marking are also given. Design considerations are discussed in Appendix X1. 1.2 The values in SI units are to be regarded as the standard. 1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—There is no known ISO equivalent to this standard. 1.4 A recommended inplant quality control program is given in Appendix X2. |
||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
Historisch
1.12.2010
Historisch
1.5.2011
Historisch
1.4.2012
Historisch
1.3.2011
Historisch
1.8.2013
Historisch
1.8.2013
Letzte Aktualisierung: 2024-11-22 (Zahl der Positionen: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.