Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors (Includes all amendments And changes 12/17/2014).
Automatische name übersetzung:
Standard Test Method for High Speed Puncture Eigenschaften von Kunststoffen über Lade- und Wegsensoren
NORM herausgegeben am 1.7.2010
Bezeichnung normen: ASTM D3763-10e1
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.7.2010
SKU: NS-24771
Zahl der Seiten: 10
Gewicht ca.: 30 g (0.07 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
falling weight, impact testing, plastics, puncture properties, Deformation--plastics, Falling weight test, High speed puncture properties, Impact resistance--plastics, Impact testing--plastics, Loading tests--plastics, Minimum instrumentation requirements, Multiaxial impact testing, Puncture, Rigid plastics, Velocity, ICS Number Code 83.080.01 (Plastics in general)
Significance and Use | ||||||||||||
This test method is designed to provide load versus deformation response of plastics under essentially multiaxial deformation conditions at impact velocities. This test method further provides a measure of the rate sensitivity of the material to impact. Multiaxial impact response, while partly dependent on thickness, does not necessarily have a linear correlation with specimen thickness. Therefore, results should be compared only for specimens of essentially the same thickness, unless specific responses versus thickness formulae have been established for the material. For many materials, there may be a specification that requires the use of this test method, but with some procedural modifications that take precedence when adhering to the specification. Therefore, it is advisable to refer to that material specification before using this test method. Table 1 of Classification System D4000 lists the ASTM materials standards that currently exist. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers the determination of puncture properties of rigid plastics over a range of test velocities. 1.2 Test data obtained by this test method are relevant and appropriate for use in engineering design. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—This specification does not closely conform to ISO 6603.2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, and specimen geometries and in test velocity can produce significantly different test results. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Bereitstellung von aktuellen Informationen über legislative Vorschriften in der Sammlung der Gesetze bis zum Jahr 1945.
Aktualisierung 2x pro Monat!
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-11-22 (Zahl der Positionen: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.