Cookies
Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
ASTM D3771-15(2022)
Standard Specification for Rubber Seals Used in Concentrating Solar Collectors
Name übersetzen
NORM herausgegeben am 1.10.2022
Informationen über die Norm:
Bezeichnung normen: ASTM D3771-15(2022)
Ausgabedatum normen: 1.10.2022
SKU: NS-1088705
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Kategorie - ähnliche Normen:
Die Annotation des Normtextes ASTM D3771-15(2022) :
This specification covers the general requirements for materials used in rubber seals of concentrating solar collectors. Design requirement pertains only to permissible deflections of the rubber during thermal expansion or contraction of the seal in use and the tolerances in dimensions of molded and extruded seals. The materials shall be classified according to usage: Type C and Type W; according to degrees of hardness: Grade 2; 3; 4; 5; 6; 7; and 8. The seals shall be classified as: Class PS and Class SC. Desert outdoor exposure and xenon arc laboratory exposure shall be performed to determine the resistance to solar radiation. The following test methods shall be performed: ultimate elongation; compression set; resistance to heating; resistance to ozone; resistance to low temperature; and adhesion loss.
Keywords:
concentrating solar collectors, preformed seals, rubber, sealing compounds ,, ICS Number Code 21.140 (Seals, glands)
Ergänzende Informationen
| 1. Scope | ||||||||||||||||||||||||||||||||||||||
|
1.1?This specification covers the general requirements for materials used in rubber seals of concentrating solar collectors. Particular applications may necessitate other requirements that would take precedence over these requirements when specified. 1.2?Design requirement pertains only to permissible deflections of the rubber during thermal expansion or contraction of the seal in use and the tolerances in dimensions of molded and extruded seals. 1.3?This specification does not include requirements pertaining to the fabrication or installation of the seals. 1.4?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5?The following safety hazards caveat pertains only to the test methods portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
Empfehlungen:
Aktualisierung der technischen Normen
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
