Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Warp (End) and Filling (Pick) Count of Woven Fabrics
Automatische name übersetzung:
Standard Test Method for Warp (End) und Füllung (Wählen) Graf von Geweben
NORM herausgegeben am 1.9.2012
Bezeichnung normen: ASTM D3775-12
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.9.2012
SKU: NS-24827
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
construction, fabric, filling pick count, warp end count, woven, ICS Number Code 59.080.30 (Textile fabrics)
Significance and Use | ||||||||||
5.1 This test method is considered satisfactory for acceptance testing of commercial shipments because it has been used extensively in the trade for that purpose. 5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias. 5.1.2 This test method is suitable for use with narrow fabrics when the count across the total width is measured in the narrow direction and extrapolated to the number of yarns per centimetre or inch. |
||||||||||
1. Scope | ||||||||||
1.1 This test method covers the measurement of warp end count and filling pick count and is applicable to all types of woven fabrics. 1.2 The values stated in SI units
are to be regarded as the standard. The values given in parentheses
are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Historisch
1.8.2011
Historisch
1.1.2007
Historisch
1.1.2013
Historisch
1.7.2014
Historisch
1.7.2014
Historisch
1.10.2013
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-11-21 (Zahl der Positionen: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.