Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Detection of Copper Corrosion from Lubricating Grease
Name übersetzen
NORM herausgegeben am 15.8.2022
Bezeichnung normen: ASTM D4048-22
Ausgabedatum normen: 15.8.2022
SKU: NS-1071825
Zahl der Seiten: 5
Gewicht ca.: 15 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
copper corrosion, copper strip, copper tarnish, lubricating grease,, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Adjunct to D130 Copper Strip Corrosion Standard for Petroleum, D1838 Standard Test Method for Copper Strip Corrosion by Liquefied Petroleum (LP) Gases, and D4048 Standard Test Method for Detection of Copper Corrosion from Lubricating Grease + Active Stan
Ausgewählte Ausführung:Significance and Use | ||||||||||
5.1?This test method measures the tendency of lubricating grease to corrode copper under specific static conditions. It may be of some value in predicting possible chemical attack on lubricated parts, such as bearings that contain copper or copper alloys. Such corrosion, for example, can cause premature bearing failures. However, no correlations with actual field service, most of which are under dynamic conditions, have been established. It does not measure either the ability of the lubricant to inhibit copper corrosion caused by factors other than the lubricant itself nor does it measure the stability of the grease in the presence of copper. Note 1:?Because this test method requires the ability to
determine subtle differences in color of copper strips, persons
with certain types of color blindness may find it difficult to
accurately compare a test strip to the Copper Strip Corrosion
Standard.
|
||||||||||
1. Scope | ||||||||||
1.1?This test method covers the detection of the corrosiveness to copper of lubricating grease. 1.2?The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-12-23 (Zahl der Positionen: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.