Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Classification System and Basis for Specification for Filled Polytetrafluoroethlyene (PTFE) Molding and Extrusion Materials Using ASTM Methods
Name übersetzen
NORM herausgegeben am 1.5.2019
Bezeichnung normen: ASTM D4745-19
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.5.2019
SKU: NS-951549
Zahl der Seiten: 6
Gewicht ca.: 18 g (0.04 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
filled compounds, filled polytetrafluoroethylene, fluorocarbon polymers, fluoropolymer, fluoropolymer composites, polytetrafluoroethylene, PTFE,, ICS Number Code 83.140.99 (Other rubber and plastic products)
1. Scope | ||||||||||||||
1.1 This standard classification system and basis for specification covers polytetrafluoroethylene (PTFE) filled molding compounds made with virgin PTFE resins defined in Specification D4894, as Types II and III. Note 1: This system can be used as a model for other PTFE
compounds having particulate fillers that can survive the sintering
temperatures of PTFE as can those listed in this standard. This
system is restricted to virgin PTFE base resin for technical
reasons. Recycled or reprocessed material cannot be processed
successfully.
Note 2: The properties measured on commercially fabricated
parts may differ from the listed values for samples prepared by the
procedures given in this specification, depending on part geometry
and processing parameters. Compounds used for ram extrusion are
made from resins that comply with ASTM-D4745 Type II prior to their
pre-sintering process. Property values measured on extruded
products will vary from the listed values for Type II compounds
which are prepared by the procedures given below which standardize
mold diameter and sintering cycle. End users should assess these
expected variations in ram extruded products to ensure their
suitable use in their specific application.
1.2 The values stated in SI units are to be regarded as standard. 1.3 The following statement applies to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 3: There is no known ISO equivalent to this standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-11-21 (Zahl der Positionen: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.