Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Guide for Measuring Some Electronic Characteristics of Ultrasonic Examination Instruments
Automatische name übersetzung:
Standard-Leitfaden zur Messung von einigen elektronischen Eigenschaften von Ultraschall- Untersuchungsinstrumente
NORM herausgegeben am 1.1.2005
Bezeichnung normen: ASTM E1324-00(2005)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.1.2005
SKU: NS-41303
Zahl der Seiten: 10
Gewicht ca.: 30 g (0.07 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
electronic characteristics, evaluation, instruments, linearity, pulsers, receivers, ultrasonic, ICS Number Code 19.100 (Non-destructive testing)
Significance and Use | ||||||
The recommended measurement procedures described in this guide are intended to provide performance-related measurements that can be reproduced under the specified test conditions using commercially available test instrumentation. These measurements indicate capabilities of sections of the ultrasonic examination instrument independent of specific transducers or examination conditions. Measurements are made from normally available connectors or test points so that no access to internal circuitry is required. Further, this guide is not intended for service, calibration, or maintenance of circuitry for which the manufacturer’instructions are available. It is intended primarily for pulse echo flaw detection instruments operating in the nominal frequency range of 100 kHz to 25 MHz, but the procedures are applicable to measurements on instruments utilizing significantly higher frequency components. These procedures can be applied to the evaluation of any pulse-echo ultrasonic examination instrument which can be described as a combination of the electronic sections discussed in this guide. Note 2—These procedures are not intended to preclude the use or application of equipment for which some or all of the measurement techniques of this document are not applicable. An ultrasonic examination instrument that cannot be completely described as a combination of the electronic sections discussed in this practice can be partially evaluated. Each portion of the ultrasonic examination instrument that is evaluated must fit the description for the corresponding section. This guide is meant to be used by electronic personnel to evaluate the electronic system components and not the ultrasonic system characteristics. |
||||||
1. Scope | ||||||
1.1 This guide describes procedures for electronically measuring the following performance-related characteristics of some sections of ultrasonic instruments: 1.1.1 Power Supply Sectionline regulation,battery discharge time, andbattery charge time. 1.1.2 Pulser Sectionpulse shape,pulse amplitude,pulse rise time, pulse length, andpulse frequency spectrum. 1.1.3 Receiver Sectionvertical linearity, frequency response,noise and sensitivity, and dB controls. 1.1.4 Time Base Sectionhorizontal linearity, andclock (pulse repetition rate). 1.1.5 Gate/Alarm Sectiondelay and width, resolution, alarm level, gain uniformity, analog output, and back echo gate. 1.2 This guide complements Practice E 317, and is not intended for evaluating the performance characteristics of ultrasonic examination instruments on the inspection/production line. Note 1No access to internal circuity is required. |
||||||
2. Referenced Documents | ||||||
|
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-08-29 (Zahl der Positionen: 2 344 943)
© Copyright 2024 NORMSERVIS s.r.o.