Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Methods for Conducting Creep, Creep-Rupture, and Stress-Rupture Tests of Metallic Materials
Automatische name übersetzung:
Standard-Prüfverfahren für Dirigieren, Creep, Zeitstand und Stress - Rupture Tests für Metallische Werkstoffe
NORM herausgegeben am 10.5.2000
Bezeichnung normen: ASTM E139-00
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 10.5.2000
SKU: NS-41591
Zahl der Seiten: 11
Gewicht ca.: 33 g (0.07 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
Creep rupture, Metals and metallic materials, Rupture/rupture strength, Stress-metallic materials, Stress rupture, metallic materials-creep/creep-rupture/stress-rupture testing, temperature, test time, thermocouples
1. Scope | ||||||||||||||||||||||||
1.1 These test methods cover the determination of the amount of deformation as a function of time (creep test) and the measurement of the time for fracture to occur when sufficient load is present (rupture test) for materials when under con- stant tension loads at constant temperature. It also includes the essential requirements for testing equipment. For information of assistance in determining the desirable number and duration of tests, reference should be made to Section 9. 1.2 These test methods list the information which should be included in reports of tests. The intention is to ensure that all useful and readily available information is transmitted to interested parties. Reports receive special attention for the following reasons: ( ) results from different, recognized procedures vary significantly; therefore, identification of methods used is important; ( ) later studies to establish important variables are often hampered by the lack of detailed information in published reports; ( ) the nature of prolonged tests often makes retest impractical, and at the same time makes difficult remaining within the recommended variations of some controlled variables. A detailed report permits transmittal of test results without implying a degree of control which was not achieved. 1.3 Tests on notched specimens are not included. These tests are given in Practice E 292. 1.4 Tests under conditions of rapid heating or short times are not included. Practices for such tests are given in Practice E21 and Practice E150. 1.5 The values stated in inch-pound units are to be regarded as the standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||
|
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-08-26 (Zahl der Positionen: 2 344 895)
© Copyright 2024 NORMSERVIS s.r.o.