Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)
Automatische name übersetzung:
Standard-Prüfverfahren für Schätzung der größten Korn in einem metallographischen Schliff Beobachtet (ALA Korngröße)
NORM herausgegeben am 1.10.2007
Bezeichnung normen: ASTM E930-99(2007)
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.10.2007
SKU: NS-48509
Zahl der Seiten: 6
Gewicht ca.: 18 g (0.04 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
ALA grain, caliper diameter, comparison procedure, ellipse measurement, grain size, largest grain, measuring procedure, metallography, microstructure, outlier grain, point-count procedure, ICS Number Code 19.120 (Particle size analysis. Sieving)
Significance and Use | ||||||||||||
The presence of large grains has been correlated with anomalous mechanical behavior in, for example, crack initiation, crack propagation, and fatigue. Thus there is engineering justification for reporting the ALA grain size. These methods shall only be used with the presence of outlier coarse grains, 3 or more ASTM grain size numbers larger than the rest of the microstructure and comprising 5 % or less of the specimen area. A typical example is shown in Annex A1 as Fig. A1.1. These methods shall not be used for the determination of average grain size, which is treated in Test Methods E 112. Examples of microstructures that do not qualify for ALA treatment are shown in Annex A1 as Fig. A1.2, Fig. A1.3, and Fig. A1.4. These methods may be applied in the characterization of duplex grain sizes, as instructed in the procedures for Test Methods E 1181. |
||||||||||||
1. Scope | ||||||||||||
1.1 These test methods describe simple manual procedures for measuring the size of the largest grain cross-section observed on a metallographically prepared plane section. 1.2 These test methods shall only be valid for microstructures containing outlier coarse grains, where their population is too sparse for grain size determination by Test Methods E 112. 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Letzte Aktualisierung: 2024-11-26 (Zahl der Positionen: 2 206 223)
© Copyright 2024 NORMSERVIS s.r.o.