Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method of Measurement of Common-Emitter D-C Current Gain of Junction Transistors
Automatische name übersetzung:
Standard Test Method zur Messung der Emitter DC Stromgewinn von Junction -Transistoren
NORM herausgegeben am 10.12.1999
Bezeichnung normen: ASTM F528-99
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 10.12.1999
SKU: NS-55623
Zahl der Seiten: 7
Gewicht ca.: 21 g (0.05 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
common-emitter d-c current gain, current gain, hFE, junction transistors, transistor test, ICS Number Code 31.080.30 (Transistors)
1. Scope |
1.1 This test method covers the measurement of common-emitter d-c current gain (forward, hFE, or inverted, hFEI) of bipolar transistors, for which the collector-emitter leakage current, ICEO, is less than 10% of the collector current, IC, at which the measurement is to be made, and for which the shunt leakage current in the base circuit is less than 10% of the base current required. 1.2 This test method is suitable for measurement of common-emitter d-c current gain at a single given value of test transistor collector current or over a given range of collector currents (for example, over the range of the transistor to be tested). 1.2.1 The nominal ranges of collector current over which the three test circuits are intended to be used are as follows: 1.2.1.1 Circuit 1, less than 100 [mu]A, 1.2.1.2 Circuit 2, from 100 [mu]A to 100 mA, and 1.2.1.3 Circuit 3, greater than 100 mA. 1.3 This test method incorporates tests to determine if the power dissipated in the transistor is low enough that the temperature of the junction is approximately the same as the ambient temperature. 1.4 The values stated in International System of Units (SI) are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Vorschriften verwenden?
Wir bieten Ihnen Lösungen, damit Sie immer nur die gültigen (aktuellen) legislativen Vorschriften verwenden könnten.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-10-30 (Zahl der Positionen: 2 208 603)
© Copyright 2024 NORMSERVIS s.r.o.