Standard Specification for Polyethylene Upright Storage Tanks
NORM herausgegeben am 15.7.2021
Warum Redline?
Redline stellt eine schnelle und einfache Art dar, wie man gesamte Änderungen zwischen einer aktuellen gültigen Norm und der Vorversion vergleichen kann.
Dank Redline werden Sie sofort informiert von:
Sparen Sie Ihre Zeit und Sorgen!
Dank Redline brauchen Sie nicht mehr zu forschen, was in der neuen Norm geändert wurde! Redline spart Ihre Zeit und stellt sicher, dass Sie über Änderungen in der Norm erfahren.
Der Preis
Wenn Sie die Variante "Gültige Norm + Redline" auswählen, bekommen Sie beide Dokumente! Und das Beste ist, dass der Preis der Gültigen Norm + Redline nur ein wenig höher ist, als der Preis der gültigen Norm selbst.
Bezeichnung normen: ASTM D1998-21
Ausgabedatum normen: 15.7.2021
Zahl der Seiten: 8
Gewicht ca.: 24 g (0.05 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
This specification covers flat-bottom, upright, cylindrical tanks molded in one-piece seamless construction by rotational molding. The tanks are molded from polyethylene for above ground, vertical installation and are capable of containing aggressive chemicals at atmospheric pressure. This specification does not cover the design of vessels intended for use at pressures other than atmospheric pressure. Furthermore, this specification does not cover the design of portable tanks and is not for vessels intended for use with liquids heated above their flash points in continuous service. Special design considerations not covered in this specification shall be given to vessels subject to superimposed mechanical forces, such as seismic forces, wind load or agitation; to vessels subject to service above specified temperature; and vessels subject to specified superimposed pressure of water. Low-temperature impact test shall be performed on rotational-molded polyethylene tanks. The test method is used on tanks molded from both the crosslinked and non-crosslinked polyethylenes. Dart drop impact test shall be performed to determine the quality of the tank. O-xylene-insoluble fraction or gel test shall be performed on crosslinked polyethylene. Visual inspection and water test shall also be performed on the samples.
Keywords:
polyethylene, tanks, upright ,, ICS Number Code 23.020.10 (Stationary containers and tanks)