Wir benötigen Ihre Einwilligung zur Verwendung der einzelnen Daten, damit Sie unter anderem Informationen zu Ihren Interessen einsehen können. Klicken Sie auf "OK", um Ihre Zustimmung zu erteilen.
Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils
Automatische name übersetzung:
Standard Test Methode zur Messung Kanten Taper und Krone von Flach Electrical Steel Coils
NORM herausgegeben am 1.11.2010
Bezeichnung normen: ASTM A971/A971M-10
Anmerkung: UNGÜLTIG
Ausgabedatum normen: 1.11.2010
SKU: NS-5119
Zahl der Seiten: 4
Gewicht ca.: 12 g (0.03 Pfund)
Land: Amerikanische technische Norm
Kategorie: Technische Normen ASTM
Keywords:
coupon, crown, edge taper, edge trim, gamma strip, master coil, slit coil, Crown, Edge taper, Electrical steel, Flat-rolled electrical steel, Gamma strip, Master coil, Slit coil, ICS Number Code 77.140.50 (Flat steel products and semi-products)
Significance and Use | ||||||||||||
Flat-rolled electrical steel master coils are usually slit into narrower coils. Usually these slit coils are punched or sheared into laminations of various shapes. The laminations are then uniformly stacked to become the cores of magnetic devices such as motors and transformers. Stacking of many laminations exhibiting excessive taper causes assembly problems and poor appearance. Nonuniform stack lengths in motors cause imbalance and noise. When the laminations are interleaved in transformers, taper causes air spaces within the core resulting in increased noise, increased exciting current, and higher core loss. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method provides a procedure for measuring edge taper and crown of flat-rolled electrical steel coils as produced at the steel mill. 1.2 The values and equations stated in customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within this standard, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this standard. 1.3 The following material specifications include requirements for edge taper or crown: A677, A683, A726, A840, and A876. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Historisch
1.5.2014
Historisch
1.5.2012
Historisch
1.10.2010
Historisch
1.5.2014
Historisch
1.11.2011
Historisch
1.7.2011
Wollen Sie sich sicher sein, dass Sie nur die gültigen technischen Normen verwenden?
Wir bieten Ihnen eine Lösung, die Ihnen eine Monatsübersicht über die Aktualität der von Ihnen angewandten Normen sicher stellt.
Brauchen Sie mehr Informationen? Sehen Sie sich diese Seite an.
Letzte Aktualisierung: 2024-12-23 (Zahl der Positionen: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.